SKÅDIS board generator

Cut-ready SVG for Shaper Origin and Shaper Studio.

Panel

Width Height

Min. edge margin Corner radius

Cut panel outline

Slots

Width Length Pitch

Staggered rows (offset half pitch) Swap stagger phase Horizontal slots

Mounting holes Add corner holes

Diameter Inset

Material and depth Material

Thickness Overcut

Export Custom anchor Include blue guide grid

The SVG always exports in millimeters, so imperial entries don't pick up rounding. Every cut path carries shaper:cutDepth set to thickness plus overcut. Slots and holes are inside cuts (black stroke, white fill); the outline is an outside cut (black fill). The anchor is a red, strokeless right triangle whose right-angle corner is the anchor point, short leg on X, long leg on Y.

0slots

0panel

0actual margins (L/R, T/B)

Cut plan

Cut	Bit	Spindle	Feed	Depth per pass	Passes

Spindle 5, 10 in/min and 1/4 in per pass come from Shaper's materials table for 1/4 in upcut bits in plywood and MDF. The 1/8 in figures are scaled from that (one bit diameter per pass, slightly slower feed). Treat all of them as starting points: back the dial off if you smell burning, raise it if the cut feels grabby.

SVG source